中文|Message|ContactHello, welcome toJiangyin Huachang Stationery Co., Ltd.The official website!

erweima

Hotline:+86-510-86201256
+86-13901527981

Jiangyin Huachang Stationery Co., Ltd.

    Current position: 跳过导航链接Home > News > News detail

    How to use the stapler?

    Return list Clicks:477Update time:2018-01-12

    1, Holding machine: the four fingers of the right hand hold the seat, the thumb is placed on the top of the fuselage, and the whole machine is held smoothly. 2, Thread: gently pull out the wire on the spool. Go through the lead, and then introduce the clip line regulator B. goes through the lead ring. The line that C. leads is placed on the side of the machine needle temporarily, and the threading machine goes through the pinhole of the machine from the front of the machine needle to the fuselage joint part, and then leads the thread into the threading hole. It pulls out the threading line and pulls out the head line about 2-3 centimeters, and the pressing plate is pressed, so it can be used. 3, Release: put up the pressboard with the right index finger, put the ready stitched fabric (thickness less than 0.8 millimeters) flat under the pressboard, gently put it back to the platen, and press the fabric. 4, Sewing operation: holding fabric with left hand, and pressing the top of the top of the cap lightly under the thumb of the right thumb, then press the thumb again, so repeatedly, the feeding mechanism automatically sends the slit to the left. Right hand holding machine gradually moves to the right, left hand holding the cloth with the sewing rhythm gently will be sewn to the left, until the end of sewing; 5, End: the end of the sewing, cut the thread with the scissors, gently pull the press board to take out the fabric. From the reverse side of the stitched fabric, pull out the last line, put it in a side coil, tighten and make a knot, and the stitch is firm. Do not pull the thread by hard pull fabric at the end of sewing, so as not to pull the needle and pin of the machine. 6, This function automatically enters and regulates the tightness between the pins of the needle, but it is necessary to pay attention to the following points: A. needle foot is too tight, the pressure nut is slightly reversed clockwise. The B. pin is too loose, the pressure regulating nut is slightly clockwise; As shown, the correct stitch is tight. If you need some stitches, left Labuke slightly faster. If you need stitches close, left Labuke slightly slower; 7, For coil; such as the use of big coil, the alternate long rod and line cylinder shaft connection, set into the large coil. At the end of the plastic cap is arranged rod fixed coil backup, and then re threading, adjust the thread tension after sewing; the best use of 50#-90# cotton or synthetic line effect; 8, Change the needle: release the fixed screw and remove the broken needle. Install on the needle, it should be smooth face is fixed screw needle, not anti loaded. Needle type DHK-14

    Contact Huachang Contact Us
    Hotline:+86-510-86201256

    Contacts:Zhaohongxi

    Mobile phone:+86-13901527981

    Tel:+86-510-86201256

    Fex:0510-86201255

    Add:Jiangyin City, Jiangsu Province town of Hua Qin Feng Road No. 989